If you are still experiencing these issues Contact Brother Customer Service for further troubleshooting by calling 1-877-Brother (1-87) Monday through Friday, excluding holidays. If you are using stabilizer that has adhesive, please be sure to remove the needle and clean between every pattern with rubbing alcohol. If you are using stabilizer that has adhesive, remove the needle and clean between every pattern with rubbing alcohol. Make sure you are using correct and enough stabilizer for the fabric you are working with. Be sure to use the correct size needle and thread for the type of fabric that you are sewing.ĩ. The combination of the needle size, thread size and fabric could be incorrect.
How to thread a double needle brother vx710 plus#
Press the plus side of the stitch length adjustment key to make your stitch longer.Ĩ. If your stitches are close together or just piling up on the stitch plate, use the stitch length adjustment key to lengthen your stitch. Make sure that your feed dogs are in the correct position. The tension should be adjusted when you change fabric or thread type. If your machine is an embroidery machine, check that the tension is set at 5. Set the tension to the basic thread tension setting or adjust the tension manually. If your machine is an embroidery machine and you are creating an embroidery design, make sure that you are using the Q foot.ĥ. The tension could be too tight or too loose. Make sure that the pressure foot you are using is correct for the type of stitch you have selected. Replace the bobbin with a new one to test and see if this could be the issue.Ĥ.
![how to thread a double needle brother vx710 how to thread a double needle brother vx710](https://www.sewingmachinefun.com/wp-content/uploads/2020/01/20200124_102725-1024x768.jpg)
The bobbin thread may not be wound properly.Ī. Make sure you are using the correct size bobbin that was designed for this machine. This is the best sewing foot for inserting zippers, snap tape, and more.
How to thread a double needle brother vx710 zip#
Make sure that there are no scratches or burrs on the bobbin case (if so, it will need to be replaced). Brother VX 710 Sewing Machine Adjustable Zip / Zipper Foot. Remove any loose threads or lint in the shuttle race by using the brush instead of blowing into the machine. Once you’ve set the needlebar height, adjust the hook timing by lowering the needlebar to the lowest position. Adjust the needle height so the needle eye is 2.4 millimeters below the point of the hook. Remove the bobbin and make sure the bobbin is inserted and threaded properly in the shuttle race. If your needlebar doesn’t have timing marks, lower the needle completely using the hand wheel, then raise it 2.4 millimeters. If your machine is an embroidery machine and you are using metallic thread, cone shaped or cross threaded spools of thread, be sure to use a spool net around the spool of thread. Make sure you are usin g the correct size spool cap for the size of the thread spool. If so, remove the thread completely from the machine and re-thread it. Check to make sure that the upper thread was threaded properly through the thread path and that it is not tangled. The thread tension is not properly set. The thread does not match the needle type (refer to manual).
![how to thread a double needle brother vx710 how to thread a double needle brother vx710](https://i.pinimg.com/originals/08/af/e4/08afe498cf975dc17ee8ab659bfa6051.jpg)
The selected pressure foot is incorrect. The top thread or bobbin has not been set correctly.